2SD datasheet, 2SD circuit, 2SD data sheet: SANYO – Low- Frequency Power Amp, Electronic Governor Applications,alldatasheet, datasheet. 2SD Rev.E Mar DATA SHEET 1 / 6. TOLM 塑封封装NPN 半导体三极管。Silicon NPN transistor in a TOLM Plastic. Characteristics of the 2SD bipolar transistor. Type – n-p-n; Collector-Emitter Voltage: 25 V; Collector-Base Voltage: 25 V; Emitter-Base Voltage: 5 V; Collector .
|Country:||Antigua & Barbuda|
|Published (Last):||7 June 2017|
|PDF File Size:||8.20 Mb|
|ePub File Size:||4.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
Issue While Rehabbing an STA-2100, What Would You Do?
I posted this same question on Diyaudio and and received good advice 2sv400 there as well. I use Chem-Wik to desolder and an industrial grade solder made by AIM for surface mount applications.
The replacement is not a TO package and there is no stock mounting clip like the other channel right.
It’s tricky to set the datashet up on the You must log in or sign up to reply here. BinkmanSep 5, Surprisingly they also the 2sd for 45 cents. Do you already have an account? I played it a bit after I bought it but it sounded a bit off so I stowed it away until I was ready to do a full recap.
Since none of the components were the same as stock I decided to follow the EW’s advice in this thread and go with On Semi replacements. CCW but I can wire in a cw plus v pot in reverse. That and a little RS flux. Share This Page Tweet. There must have been a lot of those lying around.
The replacement is a TCG Transistoe of this discussion I’ve noticed more issues.
2SD Datasheet PDF – LZG
Leave the transistor that’s there? The repairing tech used a TCG to replace the 2sd on the heat sink. Log in or Sign up. Was advised to replace the trimmer pot VR BinkmanSep 8, Hopefully, this post will aid others who wish to restore this model.
Thanks for the E nlightenment!
Now that I’ve started I found one channel must have failed because there were a lot of replacement components. No, create an account now. I know it’s hard to determine good solder on a pic with lighting and all.
Are the clamps available anywhere? If it looks good on the boards probably easier to fix maybe but transidtor it’s pretty burned out or looks like it came out of a flood? BinkmanSep 6, Thanks Glen, I will check out your recommendation. Lastly, can someone enlighten me as to the meaning of the E in brackets in the schematic.
Thinking of buying some extras, too. Discussion in ‘ Solid State ‘ started by mikte15Sep 5, I couldn’t find any. At this point what would you do? Good once over visual before you repack it. Yes, my password is: Your name or email address: Google returned Talon electronics as a source. I’m in trnasistor process of rehabbing this Realistic Datassheet had for a couple of years. Check a few traces in last pic. Glen, The ZTX looks like a very good match.